Moxa Technologies VPort 25 Instrukcja Użytkownika Pobierz pdf (Strona 39)

Moxa VPort 26A-1MP System Configuration

4-10

Auto Configuration

In a mass installation, it is time consuming to configure each of the many devices one by one. Therefore, DHCP

Opt 66/67 provides a mechanism whereby configurations can be saved on a TFTP server. Once a new device is

installed, the configurations can be downloaded to this new device automatically. By doing this, the installer

can save a lot of time and efforts in mass device installation. Follow the steps below to use the

auto-configuration function via Opt 66/67.

Step 1:

When VPort 26A-1MP enables the auto-configuration function, it will ask for the IP address from DHCP server,

and the path of the TFTP server and configuration file.

Step 2:

Once VPort 26A-1MP completes the IP settings, it will acquire the configuration file from the TFTP server, and

check if this configuration file is right or not.

NOTE

For auto

-configuration to work properly, the system should:

Have a DHCP Server that supports DHCP Opt 66/67 in the network switches and routers.

Have a TFTP server that supports the TFTP protocol

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 82 83

Brak uwag

Moxa Technologies VPort 25 Instrukcja Użytkownika Strona 39